Cobb Accessport Betriebsanweisung PDF herunterladen (Seite 9)

AccessPORT Installation Page 9

Getting Started

1. Insert the key into the vehicle's ignition and leave it in the OFF position.

2. (AP-SUB-001 and AP-SUB-002 owners only):

Locate the green Test Mode connectors. Impreza and Forester models will have this

located under the driver's side dash to the left of the steering column (see left

diagram). The Legacy and Outback models will have this located on the passenger

side (see right diagram). With the connectors located, enable Test Mode by plugging

the two connectors into each other.

NOTE: In the event that the vehicle does not enter Test Mode after plugging in the

green connectors, refer to [TROUBLESHOOTING SECTION] .

3. (AP-SUB-001 owners only):

Identify the correct Initialization Connector for your vehicle (2002 WRX = BLUE, 2003

- 2005 WRX = WHITE). Attach the Initialization Connector to the corresponding

connector under the driver's side dash. This connector will be located near the green

Test Mode connectors and will be translucent white in color. Do not proceed until this

step is complete.

Revision 1.078 Nov 21, 2012

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 22 23

Keine Kommentare

Cobb Accessport Betriebsanweisung Seite 9