Cobb Accessport Betriebsanweisung PDF herunterladen (Seite 13)

AccessPORT Installation Page 13

Installation Complete

The AccessPORT is now fully installed and ready for use. Turn the key to the OFF position

and unplug the OBD connector (Version 2) or the OBD-II cable (Version 2b) from the vehicle.

If applicable, disconnect the Test Mode connectors (green) you connected in Step 2 and the

Initialization Connector you connected in Step 3. These connectors MUST be disconnected

before operating the vehicle.

The vehicle's ECU is now programmed with new calibration data. The AccessPORT does

not need to be plugged into the vehicle for the calibration to be in effect, however, there are

other features of the device that may be used at any time.

Please note that the AccessPORT is designed to work with only one vehicle at a time. Once

the AccessPORT is installed, it cannot be used with another vehicle until it is

uninstalled from the original vehicle.

Revision 1.078 Nov 21, 2012

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 22 23

Keine Kommentare

Cobb Accessport Betriebsanweisung Seite 13