Cobb Accessport Betriebsanweisung PDF herunterladen (Seite 11)

AccessPORT Installation Page 11

6. Turn the key to the ON position but do not start the vehicle.

7. Select [Install] from the AccessPORT menu by pressing the [OK] button to proceed

with installation. Below is a diagram of the AccessPORT's keypad function.

Vehicle Identification

The AccessPORT will attempt to automatically determine the target vehicle for installation.

At this point, turn the key to the ON position and press the [OK] button on the AccessPORT

to proceed with identification.

If the AccessPORT successfully identifies the vehicle:

Verify that the identified vehicle is correct and press [OK] to confirm.

If an error occurs:

Please refer to [TROUBLESHOOTING SECTION].

Map Selection

After the AccessPORT identifies the vehicle, it will present a list of maps. Maps that are not

intended for the identified vehicle are displayed in gray. The AccessPORT will reprogram the

ECU with the calibration data from the map selected for installation. This will become the

base data for the ECU. To ensure the best performance, select the map that most closely

matches the modification level of the vehicle. If you are unsure about which map applies to

your modification level, please see the map notes and their requirements for the

modifications that will best fit your vehicle.

If you are unsure about which map applies to your modification level, please see the map

notes and their requirements for the modifications that will best fit your vehicle.

Select a map and press [OK] to view detailed information about that map. After confirming

that the selected map is correct, press [OK] again to proceed, or press [CANCEL] to return

to the map selection list.

Revision 1.078 Nov 21, 2012

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 22 23

Keine Kommentare

Cobb Accessport Betriebsanweisung Seite 11